![]() Take the screw holding the lower shock to the arm out and the screw holding the arm to the axle hub. Then, remove the 3 screws holding the rear bumper and set the bumper aside. The rear A-arms are very much like the front. Note: If you are replacing both A-arms then do not reinstall the front bumper and center suspension pin holder until you have installed both A-arms. Now reinstall the front bumper with the 5 screws originally removed. Position the suspension pin holder back in place and faster with the center screw. Reattach the shock to the arm and then fasten the steering knuckle to the arm. Slide the new suspension arm in to place on the chassis and re-install the pin removed earlier. Installing the front arms is the same as removing just in reverse order. The procedure is the same for both sides. The A-arm is now free to pull off the truck. Once the metal holder is out you can now pull the pin holding the A-arm out, you may need to use a pair of needle nose pliers. Then, remove the screw in the center of the suspension pin holder and pull outward to remove. Now, you need to remove the screw/pin holding the A-arm to the steering knuckle, and the lower shock screw holding the shock to the A-arm. There are 2 through the front and 3 on the bottom side, set that aside with the screws. Next, take the 5 screws out of the front bumper. The first thing to do is, remove the front wheels and set them aside. I am going to start with the front arms because that’s where it broke, so I’m going to change them first. I am using the blue RPM arms for my Rustler.īuy them here! Remove Front Suspension Arms RPM parts are offered in a variety of colors that you can choose from. This will add to the durability of the Rustler. This Upgrade replaces all front and rear suspension arms with new RPM arms. RPM was used for my Traxxas Rustler Upgrade Parts. Broke the A-arm, toe link and the steering linkage. That was it for the day! The Rustler 4×4 was broken. I cut the corner too tight and smacked into a tree with the right front tire with a loud thud. Running my Rustler in about 2″ of snow we had, hitting my jumps and racing around the backyard. After my Rustler 4×4 broke, I decided to write an article on how to perform a Traxxas Rustler Suspension Upgrade.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |